1 Meter RG213 Cable Low Loss Coaxial Cable PL259 M to PL259 UHF Male Connector

Genuine OEM Anytone AT-D578UV Replacement DTMF Microphone with RJ45 plug

• AT-D578UV


• AT-D578UV II Plus

AnyTone Original Type C Battery With Clip
7.4V 3100mAh Pack for AT-D878UV Plus AT-D878UV AT-D868UV AT-D878S Walkie Talkies

The Elite 3.5 LCD ZUMspot is a small and efficient Multi-Mode Digital Hotspot featuring:

• High performance 32-bit ARM processor


• Fully assembled and tested in exclusive custom injection molded case

SF20 Dual Band SMA-F 144MHz/430MHz Soft Antenna

4 position charger for Anytone DMR radios

AnyTone AT-D8x8UV series Rapid Multi-Charger can charge 4 radios or batteries at the same time and allows you to charge more efficient and faster.
When charging, indicators are red; while fully charged, will become green. The base with 4 non-slip mats.

Package Include: 1 x 4-Bay charger 1 x with Power cord

SuperMax SM-MM175 - 7" Magnet Mount With SO239 Connector

• 
  
  
  
  • 
    

    

    
    Amateur Tri-Band Base Antenna (White Fiberglass with stainless steel radials); Pre-Tuned 144MHz VHF(136-159Mhz)/220Mhz MHF(219-230Mhz/445MHz UHF(430-470Mhz);
  
  
  • Pre-tuned; No tuning needed; Length:10.3ft(3.2m) tall; Two sections; 4.7dBi actual gain VHF / 7.2 dBi actual gain MHF & 9.2dBi actual gain UHF; 1/2 wave VHF & 5/8 wave UHF;
  
  
  
  

Rainproof Speaker Microphone for AT-D878UV Dual Band DMR 

Anytone Q9 Bluetooth headset for AT-878UV and AT-D578UV
Includes: Bluetooth mono headset / Type C charging cable / User manual

Anytone AT-D578UVII v2 Plus DMR Tri-band Amateur Mobile Radio, AM Aircraft Rx with GPS and Bluetooth

Model: MAX-SM310a

Description: Tri-Band Mobile Antenna - 2m / 1.25m / 70cm

1.   Fold-over whip design permits the antenna to be tilted in any direction.

SuperMax SM-MM150 - 6" Magnet Mount With SO239 Connector

Mini 1.3 OLED ZUMspot Kit:

• High performance 32-bit ARM processor


• ZUMspot Board + antenna Fully Assembled And Tested


• Supports DMR, P-25, D-Star, System Fusion, NXDN and POCSAG


• Onboard LEDs to show status (Tx, Rx, PTT, Mode)


• Up to 10mW RF power


• SMA antenna connector, UHF antenna included


• Mounted on Raspberry Pi Zero WH


• The firmware is pre-loaded on an SD card and is easily upgraded via software.


• Built-in 1.3" OLED screen


• 3A power supply


• 1 Year Warranty


• Open source firmware (MMDVM) and software (PiStar)